Hotspot MikroTik Configuration Step by Step

Hotspot is an area where a client or user can connect to the Internet network via wireless media / wireless or wired. Whether it be a PC, notebook, other gadgets. If the speed or total internet bandwidth owned a hotspot network is not too large and without menagement appropriate bandwidth, of course, the internet speed will be noticeably slower if the user / client that accesses the Internet in the hotspot network too much. Therefore, it is necessary to overcome the bandwidth management proxy hotspot correctly.

There are many posts on how to configure Mikrotik as hotspot. But I am sure this is not the result of a cheat sheet. Even if some of section are the same, it was fate. Mikrotik is a friendly operation system, and is very easy to configured. Enough to know the concept of network, plus with a Winbox, then you will easily configure the Mikrotik, in accordance with your wishes. I configured wireless outdoor of mikrotik, as a hotspot. I forget the type of the mikrotik. It's been a long time. And now for the post on this blog, I configure the mikrotik hotspot again, but this time, the mikrotik is installed inside vmware.

Let’s begin.

Setup IP Address Ethernet.

In my case, the Mikrotik to connect to the internet, simply by setting IP address dhcp. Open winbox, Click IP – DHCP Client. In the open dialog box, click plus (+)

The new Open dialog box will be appear again, like below. Select ether1 interface, and check peer dns, ntp peer and the default route. Then click Ok.

Click new Terminal.  Make sure Mikrotik connect to internet. Use command ping.  Look at picture below.

Setting DNS

Click IP – DNS. In the open dialog box, click Settings. New open dialog will be appear. Input IP DNS in the box Servers, for example 8.8.8.8.  and check Allow Remote Requests. Then click OK.

Setting NTP (Network Time Protocol)

Click System – NTP Client. Continue to check enable and select Unicast mode, and then input IP address for Primary NTP Server & Secondary NTP Server, as shown below. Then click OK.

Setting Mikrotik Hotspot

Continue to setting Hotspot. Click IP – Hotspot

In the Hotspot dialog box, Click Hotspot Setup.

Then Mikrotik Hotspot Setup wizard, will be appear. This is easiest way to setup Hotspot interface in Mikrotik. IP address for Ethernet, DHCP Server, routing and firewall will be configured automatically. In the Mikrotik Hotspot Setup wizard, select ether2 as hotspot interface.  Then click Next.

Set hotspot IP address.  Then click Next

Set Pool dhcp, then click Next

For SSL certificate, select none. Then Klik Next

Because we don’t have SMTP server, enter 0.0.0.0. Click Next

In the wizard Setup DNS, input IP DNS, then click Next

For DNS name, leave blank, then click Next.

Create users, and password,  then click Next

Done. Setup has completed successfully.

Back to the Mikrotik Hotspot dialog box. Click tab Server Profiles, then click twice to hsprof1 (look at example picture below). New open dialog box will appear about Hotspot Server Profile.

And then in tab Login, make sure in the section “Login By”, uncheck cookie, then click OK.

Until here, Mikrotik has been successfully configured as a hotspot. For testing of the client, create a voucher for the user / client. In the Mikrotik Hotspot dialog box, select tab Users – plus (+)

In the new open dialog box, input  name & password. You can customize how the speed, duration of use, the mac address, and so on. It depends on your desire. Then click OK.

In the computer client, browsing to any site, If the login page appears, it means mikrotik hotspot is working properly. Input username and password, that have been created. If everything is normal, the browser will be redirect to destination site.

For security, don’t forget to make new password for user admin. Click system – password, fill new password in dialog box, and then click change.